Reading the numbers
Why a dash is not a failure, why nothing here rounds toward the flattering answer, and what each stamp on a figure means.
A dash means unknown. It never means zero.
Every rate on a DeVOLT screen is either measured or absent. When a yield cannot be resolved the figure that depends on it renders as an em dash, and the figures around it do not quietly fill the gap with a zero.
Unknown never blocks either
The mirror of the rule matters as much. Refusing a market because of a condition nobody checked is the same defect as asserting one, and it is the more expensive direction, because it hides something that works. A gate fires on a measured value or it does not fire.
When a check could not run at all, the number built on it says so out loud. A count that depends on an unread condition is not presented as a fact. The markets table’s Borrow tab, for instance, states which chains had their borrow-side incentives read and says that the costs on the rest are gross, because an unread incentive makes debt look dearer than it is.
Every figure carries its moment
A balance is a fact about a point in time. Anything computed from live data on these surfaces carries a measured-at stamp: relative in the open, exact on hover. A stamp that has gone stale changes colour rather than sitting quietly.
The marks you will see
- —
- Not measured. Not zero, not small, but unknown.
- *
- A measured borrow-side incentive has been subtracted from this cost.
- ⚠
- The number is real and something about it is unusual. Hovering says what.
- before incentives
- The incentive read for this chain did not happen, so the cost shown is gross and is a ceiling, not a measurement.
